title   
  

An experimental investigation of oblique cutting mechanics

Aksu, Burak and Çelebi, Ceren and Budak, Erhan (2016) An experimental investigation of oblique cutting mechanics. Machining Science and Technology, 20 (3). pp. 495-521. ISSN 1091-0344 (Print) 1532-2483 (Online)

[img]PDF - Registered users only - Requires a PDF viewer such as GSview, Xpdf or Adobe Acrobat Reader
1943Kb

Official URL: http://dx.doi.org/10.1080/10910344.2016.1196458

Abstract

In this study, an experimental investigation of oblique cutting process is presented for titanium alloy Ti-6Al-4V, AISI 4340, and Al 7075. Important process parameters such as shear angle, friction angle, shear stress, and chip flow angle are analyzed. Transformation of the data from the orthogonal cutting test results to oblique cutting process is applied, and the results are compared with actual oblique cutting tests. Effects of hone radius on cutting forces and flank contact length are also investigated. It is observed that the shear angle, friction angle, and shear stress in oblique cutting have the same trend with the ones obtained from the orthogonal cutting tests. The transformed oblique force coefficients from orthogonal tests have about 10% discrepancy in the feed and tangential directions. For the chip flow angle, the predictions based on kinematic and force balance results yield better results than Stabler's chip flow law. Finally, it is shown that the method of oblique transformation applied on the orthogonal cutting data yields more accurate results using the predicted chip flow angles compared to the ones obtained by the Stabler's rule.

Item Type:Article
Uncontrolled Keywords:Chip flow angle; cutting force coefficients; edge cutting force; oblique cutting
Subjects:T Technology > TJ Mechanical engineering and machinery > TJ241-254.7 Machine construction (General)
ID Code:30859
Deposited By:Erhan Budak
Deposited On:07 Nov 2016 11:44
Last Modified:07 Nov 2016 11:44

Repository Staff Only: item control page